2024 E-Z-GO Liberty

Seller Type: Dealership
$15,800.00

DEALER: Elliott's Custom Trailers & Carts

PHONE: (574) 268-1886

ADDRESS: 3955 Corridor Dr, Warsaw, IN 46582, USA

HOURS: Monday - Friday: 9:00am - 5:00pm
Saturday: Appointment Only
Sunday: CLOSED

WEBSITE: Dealer Website

Financing: Dealer Financing

Vehicle Specs

  • New
  • Exterior: Charcoal
  • 4 Passenger

Additional Information

Check out this amazing golf cart!

INFO
Long Top
Windshield
Mirror
Headlights
Taillights
Brake Lights
Brushguard
Fender Flares
Lithium Battery

DIMENSIONS
Overall Length – 106."
Overall Width – 48"
Overall Height (with roof) – 76"
Wheel Base – 76"
Front Wheel Track – 38"
Rear Wheel Track – 39"
Ground Clearance @ Differential – 5.5"

POWER
Power Source – 56.7V DC
Motor Type – AC Induction
Horsepower – 11.7
Electrical System – 48V Primary, 12V Auxiliary
Batteries – Single, 56.7 Vol Li-Ion Composite Module (Standard Configuration)
Pedal Start
Battery Charger – Single, 56V Li-Ion (Standard Configuration)
Speed Controller – 235 Amp AC Controller
Drivetrain – Motor Shaft Direct Drive
Transaxle – Differential with Helical Gears
Gear Selection – Dash Mounted FNR/Key Switch
Rear Axle Ratio – 17:1 (Forward)

PERFORMANCE
Seating Capacity – 4 Passenger
Dry Weight – 914 lb (without Batteries)
Curb Weight – 960 lb
Vehicle Load Capacity – 800 lb
Turning Radius – 12.85′
Outside Clearance Circle – 25.7′
Speed – 19.5 mph

STEERING & SUSPENSION
Steering – Self-Compensating Reduction Rack and Pinion
Suspension – Leaf Springs with Hydraulic Shock Absorbers
Brakes – Dual Rear Wheel Mechanical Self-Adjusting Drum
Parking Brake – Self-Compensating, Single Point Engagement

BODY & CHASSIS
Frame – Welded Steel with DuraShieldTM Powder Coat
Front Body and Finish – Injection Molded TPO
Rear Body and Finish – Thermoform ABS

Give Elliott’s Custom Trailers & Carts, located at 3955 Corridor Dr., Warsaw, IN 46582, a call (574-268-1886) for more information today!

Contact This Seller

"*" indicates required fields

Hidden
Hidden
Trade In
This field is for validation purposes and should be left unchanged.